The less axis tilt you have, the sooner the ball will go into a roll. Higher degrees of axis tilt promotes skid. Usually refers to the far end portion of the lane where the most hook can occur. If the back ends are very dry, the ball will continue to hook with power for most players; if the back ends are tight, most players will see more deflection in the pocket and fewer strikes. A ball that curves left to right for a right-handed bowler or right to left for a left-handed bowler.
Professionals normally do not throw back up balls. A full set of pins that appears to have one or more not properly positioned; generally undesirable. A method of team play in which in all five players bowl together to make one game; player 1 bowls frames 1 and 6; player 2 bowls frames 2 and 7 etc. Most Baker matches are two games, total pins.
The weight of a bowling ball is not always evenly distributed in the sphere. USBC rules allow a ball to vary 3 ounces from the drilled top half to bottom half of a ball, and one ounce from the left to right side. Before resin balls, these weights were used to subtly change the roll pattern of a ball. A ball that has negative balances tends to be influenced to turn away from the pins; a ball with positive balance will be influenced to turn into the pins.
A player is in balance if, at the point of release, they are able to complete their follow through without falling off to one side; generally means that the release and slide are simultaneous. As a general rule, if you take a bowling ball and place the label in front of you and then exactly dissect the ball into two equal halves, a right and left side, the gross weight of each half would be the same. However, if you dissect the ball off center, a greater portion of the weight block will be on one side of the ball, possibly making that half of the ball too heavy vis-a-vis the other half; also, modern high tech balls and their asymmetrical cores can be drilled in such a manner as to be in violation of the maximum tolerances allowed by the USBC for side to side weight which is a one ounce differential ; to get the ball back to legal compliance an extra, non-gripping hole may be drilled to remove the excess weight.
This extra hole is the balance hole. The physical part of the equipment upon which the ball sits after being sent back to you after a delivery. A machine that is used to spin a ball in a container so that the user can apply ball polish or sand the ball down more quickly.
Describes the type of shot where a player stands inside and tosses it to the outside in the hopes it returns to the pocket for a strike. The practice of allowing a team player to complete their game by bowling more than their scheduled turn at one time; allowed as a courtesy to a player that has other time commitments; league and tournament rules can prohibit the practice. A lane consists of 39 strips of wood, each called boards; they are usually numbered by the player and used as targeting terms; i.
A ball that had higher top weight would tend to go longer before hooking; a ball with bottom weight would tend to roll earlier. Although still used in ball drilling layouts, it is less important with the modern ball. The portion on the lane where the thrown ball begins to hook back to the pocket. Finding the proper breakpoint called "breakpoint management" is critical to the modern game. A ball that hooks too early or one that hooks too late will make it very difficult for a player to be consistent.
Breakpoints can be adjusted by making changes in alignment, target, ball, ball surface and ball speed. Refers to a ball that crosses over to the other side of the head pin opposite the side it was thrown i.
A diamond-shaped, four-pin cluster, e. Some claim it to be the for right handers, the for a lefty. The oil conditioner on the lane does not soak into the boards, it sits on top. As balls are thrown, the oil is subtly moved Usually, but not always, a house with a lot of carrydown will not allow a ball to hook as much on the back ends and scores will be lower.
Carrydown is invisible to bowlers and cannot be seen. A top professional can anticipate carrydown and make adjustments accordingly. The heaviest part of a bowling ball. A full rack of pins set up for your strike ball such that the head pin is a tad off spot towards your ball hand; i.
Another name for lane oil. All lanes need some type of protective coating to prevent burn marks in the heads from the force of the thrown balls.
In the "old days" lane conditioner was used primarily as a protective measure; today, under the System of Bowling, some centers legally use the lane conditioner as a tool to assist in scoring and guiding a ball to the pocket. A type of ball drilling where the fingers are placed up to the second joint. Not used by many higher skilled players as it is much harder to get a hook on this type of drilling, although, it may assist accuracy in some players.
The material that makes up the outer shell of the ball; the hardness, texture, and shine of a bowling ball. The number of boards that you vary from straight in your approach to the foul line. For example, if you place the inside edge of your slide foot on board 15 on the approach, but your inside edge slides on the 12 board at the foul line, you have a three board inward drift.
Releasing the ball before the sliding foot completes its slide; usually results in less hook and a weaker ball as the player does not have the proper balance and leverage to hit up on the ball. The angle relative to the pocket that the ball enters the pocket.
As a rule, increased angle means increased strikes hence the preference for a ball that hooks a lot, or for clean back ends. A type of shot that starts to the opposite side of the normal pocket and then fades back into the pocket; sometimes used on very oily lane conditions.
Describes an apparent good pocket hit that gets just eight 8 pins; typically the right-handed players will leave the spare and the left-handed players the ; usually the ball is a tad high when this happens.
The 25th board from the right right hand player. The drilling of a ball so that the finger holes are closer to the ball's label than is the thumbhole; it is a form of positive weight. A type of grip in which the fingers are inserted only as far as the first joint, allowing much more spin. For this reason it is a grip for intermediate and advanced players. Learn more about the fingertip vs. Foul Line — The line that marks the start of a bowling lane.
If your foot crosses the line, it is known as a fault and zero pins are scored. If pins were knocked down, the pins are reset before the second ball is thrown. Handicap — Usually reserved for league play, this term refers to an amount of pins added to your actual score that is meant to even the playing field for bowlers of differing skill levels. Handicaps are what makes bowling so inclusive; anyone can compete against anyone else regardless of their experience.
Head Pin — The pin that stands at the front and closest to the bowler; also known as the 1 pin. House Ball — Bowling balls that are provided by the alley, compared to a ball that you have purchased yourself. Leadoff Man — In league bowling , the member of the team who bowls first. Lift — The upward motion of a bowling ball that is created by the release of your fingers. Lofting — A common problem for bowlers, this means throwing the ball so it hits the lane hard instead of smoothly rolling it.
Often a problem of timing in the release. Perfect Game — A game of , only possible by throwing 12 consecutive strikes. Pocket — The area directly in between the head pin and the one right beside it; the pins for right handers and pins for lefties. The pocket is the best spot at which to aim because its angle has the best chance of knocking down all of the pins. Quick Eight — A good pocket hit which leaves the for right-handers, for lefties. Revolutions — Refers to the number of turns a bowling ball takes on its way down the lane.
Sandbagger — In handicap league bowling, a bowler who purposely keeps his or her average down so as to get a higher handicap. This practice is frowned upon. Write your answer Related questions. What sport uses the term turkey? Do you take of a point at the end of a bowling game if you get a Brooklyn strike? What is another term for a bowling lane? What is the origin of the word bowling? Why is the opposite pocket in bowling called Brooklyn?
What is the origin of the bowling term lily referring to the split? What is it called when you get a strike in bowling on the left side? Is Brooklyn a guy or girl name? What sport uses term turkey? What is the origin of bowling? What is the term for mass movement that is volcanic in origin? Is 'bowling pin' used in British English too alongside 'skittle'? Origin of term oceanography? What is lawn bowling?
What is the origine of name of Brooklyn? What sport does the term jack high come from? What two sports use the term strike? What is three consecutive strikes in the game of bowling called? What is the term for the origin and history of a word? What term best describes the place where a muscle begins?
How is the term nucleus related to its latin term of origin? What is the term used for a person that plays the game bowling? What is another name for gutter in bowling? What do you call a miss in bowling? Study Guides. Trending Questions.
What is the fourth element of the periodic table of elements? Still have questions? Find more answers.
0コメント